Low Pressure Pull Rod Hydraulic Cylinder

Low pressure pull rod hydraulic cylinder model naming method:

Low pressure pull rod hydraulic cylinder model naming method:

Low pressure tie rod hydraulic cylinder application scope:

1) The use of pressure range is below 5MPA;

2) The front cover, back cover and piston are made of castings, the cylinder is No. 20 steel, and the piston rod is No. 45 steel chrome-plated;

3) The default is that the cylinder is mainly subject to thrust, if it is mainly subject to tension, the customer needs to make special instructions;

4) The inner diameter range of this series of products is 63~125 mm, and the maximum thrust is 4.8 tons;

5) The default is no buffer, if the buffer is required, the customer needs to make special instructions.

Selection of installation method for low-pressure pull rod hydraulic cylinder: